Frigidaire DGGF3054KF Guida Utente

33

Entire appliance does not operate.

• The time of day is not set. The time of day must first be set in order to

properly operate the oven. See “Setting the clock” in “Setting oven

controls” section.

• Make sure power cord is plugged correctly into outlet.
• Service wiring is not complete. Contact your dealer, installing agent or

authorized service agent.

• Electrical power outage. Check house lights to be sure. Call your local

electric company for service.

• Be sure the oven controls are set properly for the desired cooking

feature. See “Setting Oven Controls” in this manual or see “Entire

appliance does not operate” in this checklist.

Poor baking results.

Oven portion of appliance does not

operate.

Solutions to common problems

•

• Be sure gas valve on regulator is turned to ON position. See installation

instructions for more details.

• Allow oven to preheat to the set temperature before placing food in oven.
• Make sure the proper oven rack position is used.
• Center food in the oven and space pans to allow air to circulate.
• Try adjusting the recipe's recommended temperature or baking time.
• If you feel the oven is too hot or cool, see Adjusting oven

temperature in Setting Oven Controls section.

Appliance is not level.

• Poor installation. To correct, place oven rack in center of oven. Place a

level on the oven rack. Adjust by turning leveling legs at base of

appliance until the oven rack is level.

• Be sure floor is level, strong & stable enough to adequately support the

appliance. If floor is sagging or sloping, contact a carpenter to correct the

situation.

• Kitchen cabinet alignment may make range appear not level. Be sure

cabinets are square & have sufficient room for appliance clearance.

Cannot move appliance easily.

Appliance must be accessible for

service.

• Cabinets not square or are built in too tightly to appliance sides. Contact

builder or installer to make appliance accessible.

• Carpet interferes with appliance. Provide sufficient space so appliance

may be lifted over carpet.

• Gas line is hard-plumbed. Have a flexible CSA International approved

metal appliance connector installed.

Oven control panel beeps and displays

F code error (for example, F10).

• The oven control has detected a fault or error condition. Press cancel to

clear the display & stop beeping. Try the bake or broil feature again. If

the F code error repeats, remove electric power from appliance, wait 5

minutes and then repower appliance and set clock for the time of day.

Try the bake or broil feature again. If the fault recurs, record fault and

call your authorized service agent.