Logic Controls kb3000 Manuale Utente

9

The following procedure will show you how to program the KB3000 with
standard (keyboard) alphanumeric characters.  The keypad can be
programmed with either ASCII or Scan code information.  The default mode
is the ASCII code mode.  The following procedure assumes a keypad and
a 101 keyboard are attached.

1.

With the correct programming graphics present.  Select the cell
you want to program by using the arrow keys on the keyboard.
The Up and Down arrows will select the row while the Shift plus
either the Right or Left arrow key will select the column.

2.

Enter your programming text.  Continue programming until all the
keys  are programmed.  It is not necessary to program all the keys
for the KB3000 to function properly.  The maximum number of al
phanumeric characters that can be programmed for any one key
is 120.

NOTE: The maximum number of alphanumeric characters that can be

programmed per keypad is 

1856

3.

Press F2 to call up the Data Transfer Menu. There
will be several choices to choose from.

4.

Type W to write the programmed data into the
KB3000’s non-volatile memory.  A “Data Wrote”
screen will open showing the percentage of
memory written.  The program will be written into
the keypad within 7 seconds.

5.

Type S to save the programmed data into the KB3 directory.  You
can select up to an 8 character name.  It will be saved with a .TPL
extension.

6.

Press ESC to terminate the Data Transfer Menu.

7.

Press F10 followed by Y to exit the utility program.

8.

To verify that your program has been successfully installed,
simply press any programmed key.  The information stored in
that key will appear on the monitor.

Dos shell
File list (*.tpl)
Load file from disk
Read from keypad
Save file to disk
Write to keypad

Press ESC to Quit