Microtek 3700 Istruzione Sull'Installazione

3

1. Check if the FilmView cover is properly installed with

its connector securely connected to its port.

Connect one end of the USB cable to your computer,
and connect the other end of the cable to the scanner’s
USB port.

4. Turn on the Power switch. The green light on the

scanner front panel will blink for a few seconds and
then stays lit. At the same time the FilmView and
scanner lamps also light up.

2. Plug the power adapter into the back of the scanner,

and plug the other end into a wall outlet or power
source.

3. Connect either the FireWire

FireWire

FireWire

FireWire

FireWire or the USB cable

USB cable

USB cable

USB cable

USB cable to your

computer and scanner. (Y

Y

Y

Y

You can use only one

ou can use only one

ou can use only one

ou can use only one

ou can use only one

interface at a time.

interface at a time.

interface at a time.

interface at a time.

interface at a time.)

If your system is FireWire-ready, connect one end of
the FireWire cable to your computer, and connect the
other end of the cable to the scanner's FireWire
connector (either one is applicable).

If your system is not FireWire-ready, you will need to
install a FireWire card. For more details on how to
install the FireWire card, please refer to the FireWire
Installation Guide on a separate sheet included with the
FireWire card.

ON OFF

FilmView cover

5. The system will detect your scanner automatically.

USB port
(labeled with
USB “

” logo)

FireWire port
(labeled with
 “ ” logo)