Nortel 4000 Nota Di Rilascio
73
Remote Access Software Version 5.3 Release Notes
300115-B Rev. A
SPR 10137
The default port mode on all PRI products has changed from cli to
auto_adapt.
auto_adapt.
SPR 10255
RIP updates should no longer stop on PPP interfaces.
SPR 9540
Annex printing no longer causes the Annex to panic.
SPR 10434
The reset annex all command now correctly updates modem type
definitions in Annex memory, depending on the new list of session
parameter blocks.
definitions in Annex memory, depending on the new list of session
parameter blocks.
SPR 9991
The rip_force_newrt parameter allows you to tune the amount of time
the RAS allows a primary router to send periodic RIP updates. If the RAS
does not hear from the primary router within this timeout period, and a
secondary router broadcasts a valid replacement route, the replacement
route takes precedence regardless of the metric. The default state for this
parameter is 0 (off), which disables the feature. The parameter can be set
for 1 to 255 seconds (the real internal minimum is 5 seconds).
the RAS allows a primary router to send periodic RIP updates. If the RAS
does not hear from the primary router within this timeout period, and a
secondary router broadcasts a valid replacement route, the replacement
route takes precedence regardless of the metric. The default state for this
parameter is 0 (off), which disables the feature. The parameter can be set
for 1 to 255 seconds (the real internal minimum is 5 seconds).