Nortel 4000 Guida Utente
Managing Remote Access Concentrators Using Annex Manager
Introduction
xx
System Requirements
Release 3.0 of Annex Manager is intended to run on a workstation running
BSD UNIX (Sun Sparc, HP, RS/6000). The following sections list the
hardware and software requirements for installing and running Annex
Manager.
BSD UNIX (Sun Sparc, HP, RS/6000). The following sections list the
hardware and software requirements for installing and running Annex
Manager.
Memory Requirements
You must have at least 10 MB of free disk space available prior to
installation. Bay Networks recommends at least 32 MB of RAM, although
specific memory requirements vary depending on the type of workstation
and the other tasks that run concurrently with Annex Manager.
installation. Bay Networks recommends at least 32 MB of RAM, although
specific memory requirements vary depending on the type of workstation
and the other tasks that run concurrently with Annex Manager.
Annex Manager works best with a color monitor directly attached to the
workstation or a color X-window terminal connected to the UNIX host
over the network. Annex Manager also supports a gray-scale X-window
terminal attached to the workstation. Any X-window terminal used with
Annex Manager must have at least 2 MB of RAM.
workstation or a color X-window terminal connected to the UNIX host
over the network. Annex Manager also supports a gray-scale X-window
terminal attached to the workstation. Any X-window terminal used with
Annex Manager must have at least 2 MB of RAM.
Platforms and Hardware
Annex Manager runs on the following platforms and hardware:
•
NT on Intel Systems 3.51, 4.0
•
NT on DEC Alpha 4.0
•
SunOS 4.1.3U and 4.1.4 on SPARC Systems
•
Sun Solaris 2.4, 2.5, and 2.5.1 on SPARC Systems
•
IBM RS6000 4.1.4, 4.1.5, 4.2
•
HP9000 10.10, 10.20
•
Linux 2.0.18