Lowrance 5200c Guida Al Funzionamento

 

39 

You can only change size, not switch layout, on the Map With Custom 

Gauges - it's always two vertical windows. Press 

 to clear the four 

flashing arrows. 
3. To change the window size again or revert back to the original dis-

play, just follow the steps above. Most dual-window displays use half 

the screen for each window by default. You can also use the Reset Op-

tions command to revert to the factory default. The following is a 12-

step quick reference for the most basic GPS operations. 

Start outdoors, with a clear view of the open sky. As you practice, try 
navigating to a location at least a few blocks away. While you're learn-
ing, navigation in too small an area will constantly trigger arrival 
alarms. 
1. Connect the unit to electric power and the antenna module. Make 

sure the MMC is in. See complete installation details beginning on 

page 11. 
2. To turn on the unit, press and release 

 key. 

3. Opening screen displays map of North America at 4,000 mile zoom 

range. Rotate through the four main Page screens (Status, Navigation, 
Map and Radar) by pressing 

|

← or → to select Status|

. This 

will bring up the Satellites Status Page. 

 

4. Wait while unit locates satellites and calculates current position. 

Process is visible on Satellite Page. This takes an average of 1 minute 

or less under clear sky conditions. "Clear sky" means open sky, unob-

structed by terrain, dense foliage or structures. Clouds do not restrict 

GPS signal reception. When the unit acquires position, a tone sounds 

and a position acquired message appears. 
5. With position acquired, press 

 key to display Map Page, which 

shows a bird's eye view of the earth. You can move around the map by: 
      Zoom in closer to see greater detail: press 

 (zoom in key.) 

      Zoom out to see more area, less detail: press 

 (zoom out key.)