CME uf5 Guida Utente

9

Hint:

You can also use MIDI cable to connect UF keyboard to computer music

system via a MIDI interface, in this way you do not have to make USB
connection, nor to install USB driver.

1.5 Driver installation

1.5.1 Connect UF to computer via USB cable
1.5.2 Power on the computer
1.5.3 Insert UF CD-ROM to computer
1.5.4 Follow instructions in the README file to finish the installation.

Hint:

When using USB cable to connect UF keyboard to computer music

system, you must install the UF driver to the computer; otherwise the system
will not accept the device.

2. Play the instrument

2.1 Turn on the instrument

You can find the Power switch in the rear panel. Make sure all the

devices are properly connected before turn on the keyboard.

2.2 Play the demo song (DEMO)

 There is one demo song in the UF keyboard. You can play the

demo song according to below steps:

2.2.1 Turn on UF keyboard, tone generator, and speaker system
2.2.2 Set proper volume for speaker system to avoid damage to

your ear

2.2.3 Push V.CURVE and A.TOUCH  on UF front panel at the

same time to play the demo song. Push the two buttons again to stop.

2.3 Reset

 By using "Reset" function, you can restore the UF keyboard to

its factory default settings. (Without "Reset", the keyboard always memo-
rize its recent settings.)

2.3.1 Push  SPLIT and  DUAL" on UF front panel at the same

time and keep the buttons hold down for at least two seconds to acti-

Play the instrument