Extreme 3802 Guida All'Installazione
194
Extreme Networks Consolidated "i" and "e" Series Hardware Installation Guide
Alpine 3800 Series I/O Modules
FM-24MFi Module
Figure 108 shows the FM-24MFi module.
Figure 108: FM-24MFi module
The FM-24MFi module has 24 100 Mbps Ethernet ports, using standard MT-RJ connectors. The
FM-24MFi module supports 100BASE-FX in multi-mode only.
FM-24MFi module supports 100BASE-FX in multi-mode only.
The default configuration of the FM-24MFi module is as follows. All ports:
•
Are added to the default VLAN as untagged.
•
Inherit the properties of the default VLAN (protocol type, VLANid, and so forth).
•
Operate in 100 Mbps, multi-mode. Half-duplex mode is not supported.
The total optical system budget for the FM-24MFi module is 11 dB. Measure cable plant losses with a
1310 nm light source to verify that your cable plant losses are within the optical budget. Table 115 on
page 352 describes the optical specifications for the FM-24MFi module
1310 nm light source to verify that your cable plant losses are within the optical budget. Table 115 on
page 352 describes the optical specifications for the FM-24MFi module
LEDs
The FM-24MFi module has the following LEDs:
•
Module status
•
Port status
For information about the LEDs and their activity on the FM-24MFi module, see “I/O Module LEDs”
on page 202.
on page 202.
Software Requirements
The SMMi requires ExtremeWare version 6.1.5 or later to operate the FM-24MFi.
38_FM24F
Module status LED
24
23
22
21
20
19
18
17
16
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
100 Mbps ports
with status LEDs