Intermec 2430 Guida Utente
Chapter 6—Configuration Command Reference
Trakker Antares 2400 Family System Manual
253
Note: The RF or Ethernet network cannot be activated if the first address
segment in the IP address is set to 127 or a number greater than 223.
segment in the IP address is set to 127 or a number greater than 223.
Default: 0.0.0.0 (DHCP enabled)
Note: If you are using the TCP/IP network, the default terminal IP
address enables the terminal as a DHCP client. For more information, see
“DHCP (Terminal)” on page 174.
address enables the terminal as a DHCP client. For more information, see
“DHCP (Terminal)” on page 174.
Menu System: Main Menu > Configuration Menu > Communications Menu > Primary
Network
Bar Codes: To set the default terminal IP address, scan this bar code:
Default Terminal IP Address (DHCP enabled)
*$+ND0.0.0.0*
*$+ND0.0.0.0*
Or: To set the terminal IP address:
1
Scan this bar code:
Enter Accumulate Mode / Set Terminal IP Address
*+/$+ND*
*+/$+ND*
2
Scan a numeric value from 0 to 255 to set an n field of the terminal IP
address from these bar codes.
address from these bar codes.
*0*
*1*
*0*
*1*
*2*
*3*
*2*
*3*
*4*
*5*
*4*
*5*
*6*
*7*
*6*
*7*
*8*
*9*
*8*
*9*
3
Scan this bar code:
. (Period)
*.*
*.*
4
Repeat Steps 2 and 3 to set the next three numbers in the terminal IP
address field. After you scan the last address segment, go to Step 5. Do
not scan the period after the last address segment.
address field. After you scan the last address segment, go to Step 5. Do
not scan the period after the last address segment.