Intermec 2430 Guida Utente
Appendix A—Default Configurations and Command Syntax
Trakker Antares 2400 Family System Manual
273
Operations Default Configuration (continued)
Operations Command
Default Value
Decode Security
Moderate
Display Backlight Timeout
10 seconds
Display Spacing
00000 (8x8 font size, no column spacing, no row
spacing)
spacing)
Display Contrast
3 (maximum contrast)
Display Cursor Style
Display Font Type
8x16 font
Display Row Spacing
0
Display Video Mode
Original
Flash Memory Configuration
0 (flash memory for double-byte fonts)
Keypad Caps Lock
Caps lock off
Keypad Clicker
Enabled
Keypad Control
Enabled
Keypad Type
Hardware default
Postamble
No characters (disabled)
Preamble
No characters (disabled)
RAM Drive Size
0 (no RAM drive)
Resume Execution
Allowed
Scan Ahead
Disabled
Scanner Mode
One-Shot mode
Scanner Redundancy
Normal
Scanner Selection
Specific integrated scanner installed on the
terminal (integrated scanners). All compatible
scanners (tethered scanners)
terminal (integrated scanners). All compatible
scanners (tethered scanners)
Scanner Timeout
Disabled (no timeout)
Scanner Trigger
Level triggering
Suspend/Resume Control
Enabled
Symbology Identifiers
000 (All symbology identifiers disabled)
Time and Date
The date of the most recent firmware installation
or upgrade. (See note below.)
or upgrade. (See note below.)
Time in Seconds
Disabled
Note: When you restore the default configuration,
Time and Date is not reset to the default value.
Time and Date only returns to its default value
when you boot the system, upgrade the firmware,
or perform a destructive reset.
Time and Date is not reset to the default value.
Time and Date only returns to its default value
when you boot the system, upgrade the firmware,
or perform a destructive reset.
Time Zone
8 Pacific Standard Time (PST)