Intermec 9710 Guida Di Riferimento
DEC VT and VXT Series
C d 39
12
DEC VT and VXT Series
This section covers these workstations:
• DEC VT240
• DEC VT420
• DEC VT220
• DEC VT340
• DEC VT241
• DEC VT1000
• DEC VT320
• DEC VT1200
• DEC VT330
• DEC VXT2000
The individual Wedge Interface Guide corresponding to this section is part number
054134.
054134.
Cables
Use the two cables supplied with this WIF kit to connect the reader to your workstation
and keyboard, as shown in your Wedge Reader User’s Manual. To order a replacement
cable, use these part numbers:
and keyboard, as shown in your Wedge Reader User’s Manual. To order a replacement
cable, use these part numbers:
• Wedge interface kit (P/N 054133)
• Keyboard cable (P/N 054132)
• Terminal cable (P/N 054131)
• Keyboard cable (P/N 054132)
• Terminal cable (P/N 054131)
Power Supply
The reader requires an external power supply only if you use a laser scanner with these
workstations. Otherwise, the reader does not require an external power supply. For
either type of power supply, set the PCB jumper to connect pins 2 and 3 on the reader’s
rear panel.
workstations. Otherwise, the reader does not require an external power supply. For
either type of power supply, set the PCB jumper to connect pins 2 and 3 on the reader’s
rear panel.
Note: If you use an external power supply with the reader, you must plug in the power
supply before switching on the workstation. If you do not, the reader will lock up.
supply before switching on the workstation. If you do not, the reader will lock up.
DEC VT420 Firmware Version
If you are using a DEC VT420, you must determine the terminal’s firmware version
(1.x or 2.x) before you configure the reader.
(1.x or 2.x) before you configure the reader.
To determine the firmware version
1. Turn on the VT420 terminal.
2. Press
F2 (Alt-Setup). The firmware version (1.x or 2.x) is displayed on the right
side of the screen. Take note of the number.