Intermec 9730 Istruzione Sull'Installazione
4. Output transmission settings RS-232
MicroBar 9730 - Installation Manual
41
ACK
- activating ACK or NAK activates the ACK/NAK protocol
- before reading a new bar code after transmission, the product waits until the end of the
hardware/software protocols time-out
- "beep after transmission" if good read ("beep before transmission" also possible - see section 7,
"Operating settings")
- 6 error beeps if no ACK (positive acknowledge) received from the host system before end of
timeout
- ENQ/ACK/NAK exclusive with XON/XOFF and RTS/CTS
not used (*)
\48\3E\00\60
used (ACK 06h)
\48\3E\06\60
compose:
\48\60
enter an ASCII character and scan End Selection
(Appendix A)
(Appendix A)