Oregon Scientific psm06a Manuale Utente
9
EN
SWITCH BETWEEN MODES
Press SELECT. The selected mode will flash. The
display will stop flashing if no key is pressed within
5 seconds.
Press SELECT. The selected mode will flash. The
display will stop flashing if no key is pressed within
5 seconds.
CHANGE SETTINGS
Press and hold SELECT for 2 seconds. Then, press
UP or DOWN to change each setting. Press SELECT
to switch options.
Press and hold SELECT for 2 seconds. Then, press
UP or DOWN to change each setting. Press SELECT
to switch options.
REMOTE UNIT SET UP
Up to 3 remote units can be used with this product to
monitor outdoor temperature and humidity. The
measurement unit (
monitor outdoor temperature and humidity. The
measurement unit (
°
C or
°
F) and channel number
(1, 2, or 3) switches are located in the battery
compartment, and should be set prior to installation.
compartment, and should be set prior to installation.
Additional remote units sold separately. If you
are using more than one remote unit, be sure to select a
different channel number for each unit.
different channel number for each unit.
INSTALLATION
Mount the remote unit on a flat surface using the recess
hole on the back of the unit.
Mount the remote unit on a flat surface using the recess
hole on the back of the unit.
For best results:
•
•
Before you insert the batteries, select the
measurement unit and channel number first.
measurement unit and channel number first.
•
Place the unit out of direct sunlight and moisture.
•
Do not place the remote unit more than
20 - 30 meters (60 - 90 feet) from the main
(indoor) unit.
20 - 30 meters (60 - 90 feet) from the main
(indoor) unit.
NOTE
PS M06 English R19
7/16/03, 1:05 PM
9