SATO CG412 Guida Utente

Section 2: Installation

Page 2-5

With the power supply off, pull the cover open/close 
latches on both sides of the printer toward you to unlock 
the top cover, and then open the top cover. 

Make sure that the cover rests firmly so that it will not fall 
forward and injure your hands.

Pass the fan-folded media through the opened window 
at the rear of the unit. 

Make sure the printed side of the media is facing 
upwards.

While holding the media guide slide lever, adjust the 
width of the media holder 

 to match the media size. 

After pulling out the media, pass the media through the 
media guides and place the leading edge of the media 
on top of the platen roller.

Close the top cover until it clicks into position. 

• Be careful not to get your fingers pinched while 

closing the top cover.

• If the optional cutter or dispenser has been 

purchased, see Section 8.1 Optional Accessories - 
Cutter and Section 8.2 Optional Accessories - 
Dispenser on how to route the media.

1

1

2

1

Media 
holder 
slide 
lever

Media 
guides

1