SATO CG412 Guida Utente

Section 3: Operation and Configuration

Page 3-8

This mode produces test labels for diagnostic purposes.

Preparation:
Make sure the media or ribbon (if required) are properly loaded in the printer. 

• If you missed the chance to release the FEED/LINE button in step 2 above, just keep holding the FEED/

LINE button and wait for the next cycle.

• If you released the FEED/LINE button at the wrong ON LINE (POWER) or ERROR indicators, just turn off 

the power and restart the procedure.

• The printer will continuously print the Factory test labels until the FEED/LINE button is pressed. The print-

ing is paused and will resume printing if the FEED/LINE button is press again.

To terminate the Factory Test Print mode
First, ensure that you have pressed the FEED/LINE button to pause the test printing, then press POWER to 
turn off the printer.

Printer start-up

While pressing 
FEED/LINE button, press 
and release POWER 
button. Keep holding 
FEED/LINE button.

Green light

Release FEED/LINE 
button when ERROR 
indicator changes to red 
light and two short beeps 
sound are heard.

Blinking green light

Press FEED/LINE button 
to start test printing.

Factory Test Print 
mode is activated and 
then paused.

Green light

FactoryTest Print start 
and print continuously.

Press FEED/LINE button  
to pause the test printing.
Press again to resume.

Factory Test Print 
paused.

Blinking green light

Printer status

Procedures

(The printer will cyclically 
advance to next mode as 
long as the FEED/LINE 
button is held down.)

Off

indicator

indicator

Buzzer

User Test Print Mode.

Factory Test Print 
Mode.

Off

Off

Off

Off

One short
beep

Two short
beeps

FEED/LINE
released

Red light

Off

Red light