SATO CG412 Guida Utente

Section 8: Appendix

Page 8-11

The printer behavior when paper end is detected is as follows:
• After printing and feeding label (2) 50mm (2”), “Paper end error” will occur. 
• If an error occurs while printing, label (2) will be printed again after releasing the error. If the print job is 

completed at the time of error occurrence, label (2) will not be printed again. (Also, when the print job is 
completed while feeding the label 50mm (2”), the label will not be reprinted.) 

• In cutter mode, cutting motion will not occur when the printer has a “Paper end error.”

The paper end detection is performed by the I-Mark sensor, therefore, the above motion may not occur 
depending on the adjustment of the I-Mark sensor.

Ribbon End detection is only available for CG408TT and CG412TT printers.

Printer behavior when ribbon near end is detected is as follows:
• Ribbon near end can be detected by setting printing method to thermal transfer.
• When the ribbon remaining becomes 5 to 7m (16.4 ft. to 22.9 ft.), “Ribbon near end” will be detected. 

The status of ribbon near end will be returned if status request (ENQ) is made.

Printer behavior when ribbon end is detected:
• Ribbon end can be detected by setting printing method to thermal transfer.
• If the print job is completed at the time of “Ribbon end error”, the label will not be printed again after 

releasing the error.

• If “Ribbon end error” occurs while printing, the label will be printed again after releasing the error.

Media feed direction

I-Mark

Feeds 50mm

 

(1)

(2)

(2”)