IBM 600e Guida Utente
You have finished the entire procedure.
If you want to change the COM port for the infrared
communication, go on to Assigning a COM Port for the Infrared
Port.
Port.
If you want to configure the infrared port for dial-up networking,
go on to Configuring the Infrared Port for Dial-Up Networking.
Assigning a COM Port for the Infrared Port
Setting COM 1:
If you want to assign a COM port other than the
default value (COM 1), you need to run the ThinkPad Configuration
program.
program.
Setting COM 2:
1
Click on the Infrared Port icon in the ThinkPad Configuration
program.
program.
2
Click on Advanced...; then click on COM2 for COM Port.
Make sure that Enable is selected for “Infrared.”
Make sure that Enable is selected for “Infrared.”
3
Shut down and restart your computer.
After you modify the registry key or value, restart the computer. The
infrared port is configured as COM2.
infrared port is configured as COM2.
Configuring the Infrared Port for Dial-Up Networking
To use dial-up networking with the infrared port, you need to
configure the null-modem setting in the “Windows NT RAS setup”
window.
configure the null-modem setting in the “Windows NT RAS setup”
window.
To set up infrared communication for dial-up networking:
1
Double-click on the Network icon in the Control Panel.
2
Click on the Services tab; then click on Add....
3
If you have not installed Remote Access Service, click on
Remote Access Service, and click on OK.
Remote Access Service, and click on OK.
Chapter 8. Installing Software
137