IBM 600e Guida Utente
Appendix A. Using PS2 Commands
Using PS2 Command
This section describes PS commands in general. Depending on the
features of your computer, some commands might not apply. Please
note that the
features of your computer, some commands might not apply. Please
note that the
PS2
commands are subject to change without notice. If
you enter a command written in this section and receive an error,
type
type
PS2 ?
and refer to the online help menu.
You can enter the following
PS2
command options from the DOS
command prompts on DOS, Windows 3.1, Windows NT, Windows
95, Windows 98, and OS/2 to set the features for your computer.
When entering a command, enter it in the following syntax:
95, Windows 98, and OS/2 to set the features for your computer.
When entering a command, enter it in the following syntax:
PS2
[
Parameter1] [Parameter2] [Parameter3]
|
Note:
You cannot use the following
PS2
commands in the Windows
|
98 environment:
PRESENtation
HTimer
POwer
DISK
LCd
ON
TImer
DEFAULT
Syntax Rules
Refer to these notes when you enter a command.
Copyright IBM Corp. 1998
173