McCall 1-1020f Guida Specifiche

Stainless steel cabinet interior and exterior front, sides and doors.

Stainless steel cabinet exterior front, sides and doors. 
Heavy gauge aluminum cabinet interior with stainless steel floors.

Heavy gauge anodized aluminum cabinet exterior sides. 
Stainless steel cabinet fronts and doors except for aluminum ends that
wrap around front.
Heavy gauge aluminum cabinet interior with stainless steel floors.

Cabinet - Cabinets are all metal, inside and out. The
top, back, and bottom are made of galvanized steel.
In addition, all seams are closed and sealed, with
metal edges turned away from the exposed surface.
The result is an integrated structural frame. Internal
corners are coved to conform to NSF standards.
Automatic interior lighting is controlled by a light
switch concealed in the door hinge, except glass
door models employ a manual switch.

Doors - Constructed of metal, refrigerator doors
are self-closing and fully insulated. Cam-lift
hinges are chrome-plated and self-lubricating.
Hinges also have a safety stop that holds the door
open, preventing overswing. Chrome-plated pull
handles have built-in cylinder locks. The full-
perimeter, magnetic vinyl gaskets are removable
without the use of tools. Doors easily lift off, and
door openings have a built-in, low wattage, anti-
condensate heater. Door openings are protected
by an impact-resistant, nonconductive PVC

breaker strip with no exposed screws or fasteners.

Insulation - Cabinet body, doors, and evaporator
coil housings are filled with pressure-injected
polyurethane foam.

Interior Shelves - Three wire shelves per section
are standard. Shelves have a runner spaced 3/4
inch O.C. with two reinforcing bars 8 1/2 inch O.C.
Coated with 7 mils of baked-on gray epoxy. The
shelves have a saline spray corrosion resistance of
600 hours. Shelves will support 250 lbs. each with
maximum cabinet load of 800 lbs. They are
supported on stainless steel pilasters (1000 series)
and aluminum pilasters (2000-4000 series), and are
adjustable on 1 inch centers. All three shelves are
interchangeable and can be adjusted without tools
or special parts.

Self-Contained Refrigeration - The complete
refrigeration assembly is mounted on top of the
cabinet behind a removable hatch cover.

Refrigeration components include a hermetically
sealed compressor, thermostatic expansion valve,
thermostatic temperature control, high-humidity
coated evaporator coil and hot gas condensate
evaporator. The system is balanced to maintain
38°F average internal air temperature. Windrunner
gradient air displacement process provides even
air flow and temperature control throughout the
cabinet. All components are factory installed and
tested, and supplied with an attached cord and
plug (self-contained, 115 volt only less than 16
amps), master power switch, and exterior digital
thermometer (1000 series) dial thermometer
(2000-4000 series).

Remote Cabinets - Standard remote units are
provided with capped refrigeration lines, expansion
valve, solenoid valve, electric condensate
evaporator, and temperature control. Condensing
unit is not included. All other features are the same
as self-contained units, except power cord.

• Top mounted compressor and evaporator coil 
• Expansion valve 
• Hot gas condensate evaporator 
• R-134a refrigerant
• Cord and plug attached (self-contained only) 
• Windrunner gradient air displacement process
• Exterior digital thermometer (1000 series) dial thermometer (2000-4000 series) 
• Self-closing cam-lift hinges 
• Chrome-plated door handles with security locks 
• 6 inch adjustable legs 
• Baked epoxy-coated shelves adjustable on 1 inch centers 
• Concealed light switches housed in hinge
• Stainless steel pilasters (1000 series) & aluminum pilasters (2000-4000 series)
• Automatic defrost
• Adjustable doorstops

CLASSIFIED TO

NSF (STD-7-1999)

McCall Refrigeration specification sheets are available online
@ www.mccallrefrigeration.com