McCall 7-7020ft Guida Specifiche

Cabinet exterior: heavy gauge anodized aluminum.     Stainless
steel door and hatch cover.
Cabinet interior: mill finish aluminum.

• Top mounted compressor and evaporator coil 
• Hot gas condensate evaporator 
• Automatic defrost. 
• Cord and plug attached 
• Master power switch. 
• Windrunner gradient air displacement process
• R-404A refrigerant 
• Automatic interior light. 
• Dial Thermometer. 
• Adjustable doorstops

Cabinet - Cabinets are all metal, inside and out.
The top, back, and bottom are made of galvanized
steel. In addition, all seams are closed and sealed,
with metal edges turned away from the exposed
surface. The result is an integrated structural
frame. Internal corners are coved to conform to
NSF standards. Automatic interior lighting is
controlled by a light switch concealed in the door
hinge. The cabinet is supported on four 6 inch
adjustable steel legs.

Doors - Constructed of metal, refrigerator doors
are self-closing and fully insulated. Their cam-lift
hinges are epoxy-coated and self-lubricating.
Hinges also have a safety stop that holds the door
open, preventing overswing. Chrome-plated pull
handles have built-in cylinder locks. The full-
perimeter, magnetic vinyl gaskets are removable 

without the use of tools. Doors easily lift off,
and door perimeters have a built-in, low wattage,
and anti-condensate heater. Door openings are
protected by an impact-resistant, nonconductive
PVC breaker strip with no exposed screws 
or fasteners.

Insulation - Cabinet body, doors, and evaporator
coil housings are filled with pressure-injected
polyurethane foam.

Interior Shelves - Three wire shelves are standard
per section. Shelves have a runner spaced 3/4 inch
O.C. with two reinforcing bars 8 1/2 inch O.C.
coated with 7 mils of baked-on gray epoxy. The
shelves have a saline spray corrosion resistance of
600 hours. Shelves will support 250 pounds each.
They are supported on stainless steel pilasters
(1000 series) & aluminum pilasters (2000-4000

series), and are adjustable on 1 inch centers. All
shelves are interchangeable and can be adjusted
without tools or special parts.

Self-Contained Refrigeration - The complete
refrigeration assembly is mounted on top of the
cabinet behind a removable hatch cover.
Refrigeration components include a hermetically
sealed compressor, 1 & 2 section have cap tube 
(3-section uses expansion valve), thermostatic
temperature control, high-humidity evaporator 
coil and hot gas condensate evaporator. The
system is balanced to maintain 0°F average
internal air temperature. Windrunner gradient air
displacement process provides even air flow and
temperature control throughout the cabinet. All
components are factory installed and tested, and
supplied with an attached cord and plug, master
switch, and interior thermometer.

McCall Refrigeration specification sheets are available 
online @ www.mccallrefrigeration.com

CLASSIFIED TO

NSF (STD-7-1999)