Panasonic dmc-fz10 Manuale Utente
Recording pictures (basic)
40
ª Adjusting flash output
Adjust the flash output when the subject
is small or reflection ratio is extremely
high or low.
is small or reflection ratio is extremely
high or low.
1
Press
3 until [
FLASH]
appears on the screen to set the
flash output.
flash output.
• You can adjust this from
j2 EV to
i2 EV in steps of 1/3 EV.
• The determined flash output is
memorized even if the camera is
turned off.
turned off.
¬Suggestions/Tips ¬
• In Night portrait mode [
], flash
setting is fixed to Slow sync./Red-eye
reduction [
reduction [
].
• In Motion image mode [
] or when
the flash is closed, flash setting is fixed
to the Forced OFF [
to the Forced OFF [
].
• When using the flash in ISO AUTO
setting, the ISO sensitivity is
automatically adjusted from ISO50 to
ISO400. To avoid noises, decrease the
ISO sensitivity.
automatically adjusted from ISO50 to
ISO400. To avoid noises, decrease the
ISO sensitivity.
• Do not stare at the photo flash from
close proximity when using the
flash.
flash.
• If you bring the flash too close to
the subjects, they may be distorted
or discolored by its heat and
lighting.
or discolored by its heat and
lighting.
• Do not cover the photo flash with
your fingers or any other items.
• If the subject is too close when using
the flash, the picture may be over
exposed.
exposed.
• When the jitter alert appears, we
recommend using the flash.
• When you set to burst mode or auto
bracket, only 1 picture is recorded for
every flash activated.
every flash activated.
• The flash icon turns red when
activating the flash and pressing the
shutter button halfway.
shutter button halfway.
• When the flash is being charged, the
flash icon blinks red, and you cannot
take a picture even when you press
the shutter button fully.
take a picture even when you press
the shutter button fully.
• When taking a picture with the
flash, we recommend removing the
lens hood. In some cases it may not
allow the scene to be illuminated
properly.
lens hood. In some cases it may not
allow the scene to be illuminated
properly.
• When taking a picture with the flash,
the white balance will be automatically
adjusted [except for [
adjusted [except for [
] (Daylight)
and [
] (Flash)], but the white
balance may not be properly adjusted
when the photo flash is insufficient.
when the photo flash is insufficient.
• When the shutter speed is fast, the
flash effect may not be sufficient.
• To avoid noises, we recommend
setting each item on [PICT.ADJ.] to
[LOW]. (P79)
[LOW]. (P79)
• Refer to P74 for the ISO sensitivity.
• Refer to P84 for the external flash.
• Refer to P84 for the external flash.
FLASH
SET
WB
REVIEW
SET
WB
REVIEW
SET
WB
REVIEW
EXIT
SELECT
WB
FZ10-PP.book 40 ページ ２００３年１１月１８日 火曜日 午後１時７分