Panasonic ag-ez50 Guida Al Funzionamento

Pagina di 58
12
CGR-D08A/1B 
VSB0419
CGR-D16A/1B
CGP-D28A/1B
A
B
A
B
A
B
A
B
1 h. 
2 h.
3 h 15 min.
1 h 10 min. (55 min.)
2 h 25 min. (2 h.)
4 h 15 min. (3 h 35 min.)
5 h 20 min.
8 h. (6 h 40 min.)
CGR-D53A/1K
PUSH
BATT.
EJECT
1
2
1
2
1
3
4
Power Supply
ª Using the AC Adaptor
1
Slide the Viewfinder backward and then tilt it upward.
2
Insert the battery-shaped connector of the DC Cable into the 
Battery Holder on the Camera/Recorder.
3
Connect the DC connector plug to the [DC OUT] Jack on the 
AC Adaptor. 
4
Connect the AC Adaptor and AC Cable.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
ª Using the Battery
≥Before use, fully charge the battery.
Attach the Battery to the AC Adaptor and charge it.
≥Since the Battery will not be charged when the DC Cable is connected 
to the AC Adaptor, disconnect it.
≥The [CHARGE] Lamp lights up, and charging starts.
≥When the [CHARGE] Lamp goes off, charging is completed.
Attach the charged Battery to the Camera/Recorder.
Disconnecting the Power Source
Set the [OFF/ON/MODE] Switch to [OFF] and, while pressing the 
[BATT. EJECT] Button 
1
, slide the Battery or DC Cable upward to 
disconnect it.
≥For other notes, see page 46.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Charging Time and Available Recording Time 
A
 Charging Time
B
 Maximum Continuous Recording Time
≥“1 h 20 min.” indicates 1 hour and 20 minutes.
≥Battery VSB0419 is supplied.
≥The hours shown in the table below are approximate hours. The numeric 
characters in parentheses indicate the recording time when the LCD 
monitor is used. In actual use, the available recording time may be shorter 
in some cases.
≥The hours shown in the table below are for continuous recording at a 
temperature of 68
xF (20xC) and humidity of 60 %. If the Battery is charged 
at a higher or lower temperature, the charging time may become longer.