Wasp wpa206 Guida Di Riferimento

50

Wasp WPA206

Terminal does not power on

Terminal shuts itself down

Battery life is short

“Low Backup Battery” message

Screen is blank

Terminal either does not
respond, or responds inaccu-
rately to touch screen input.

Bar code does not read

Terninal will not shut off

Charge terminal for 16 hours

Battery needs recharging or replacement

Insure that the battery is installed correctly

Adjust “Power Properties”

Battery needs recharging

Adjust “Power Properties” - especially if peripherals are
used

Adjust backlight of LCD or Keypad

Replace battery pack if old (battery can be recharged
approximately 500 cycles)

Make sure the terminal is powered on

Adjust screen brightness

Calibrate touch screen

Perform a warm boot - WARNING - Unsaved data will
be lost

Perform a cold boot - WARNING - Terminal will be
reset to factory default settings and data will be lost

Make sure scanning application is loaded and opera-
tional

Run “Scanner Setting” program to modify barcode read
setting

Bar code might be distorted and should be replaced

Battery needs recharging or replacement

If terminal is processing data, attach charging cable to
insure the battery isn’t depleted

If terminal is connected to AC power, disconnect

Perform a warm boot - WARNING - Unsaved data will
be lost

Perform a cold boot - WARNING - Terminal will be
reset to factory default settings and data will be lost