Nxg pro 1030 Guida Utente

If the NXG speaker system proves to be defective in workmanship 

or materials within three years from the date of the original cus-

tomer’s purchase, we will, at our option, repair or replace the

defective product.

Any implied warranties, including warranties of merchantability 

and fitness for a particular purpose, are limited in duration to the

length of this warranty.

NXG’s liability for any defective product is limited to repair or 

replacement of the product at our option. NXG shall not be liable

for incidental or consequential damages of any kind or character

because of product defects. Some states do not allow limitations

on how long an implied warranty lasts and/or do not allow the

exclusion or limitation of incidental or consequential damages,

so the above limitations and exclusions may not apply.

• Damage caused by abuse, accident, misuse, negligence, or 

improper operation. 

• Any product whose serial number has been altered, defaced, 

or removed.

• Products that have been altered or modified.

• Normal wear and maintenance.

• Damages caused by shipping. (All claims for shipping damage

must be made with the carrier.)

Warranty service must be performed by an authorized service

center, usually an NXG speaker systems dealer or its authorized

agent. You may obtain a list of authorized service centers by con-

tacting NXG. All warranty repairs must be accompanied by the

original bill of sales. No other document is acceptable or is

required. This warranty gives you specific legal rights, and you

may also have other rights which vary from state to state.

1. Determine speaker locations and mark them on your plans for future reference.

2. If possible, run speaker wires after HVAC and electrical wiring is in place.

3. Secure speaker wires in place along the run with insulated staples only and

be careful not to pierce the wire’s insulation. Allow a bit of slack for expan-

sion of building materials.

4. The actual speakers should not be installed until the wall board is in place.

In the meantime, leave several feet of wire coiled up and secured at the back

side of the mounting hole. 

5. To complete the installation follow steps 2 through 5 above.

6. See Fig. 5. With the speaker wire attached to the speaker, slide the 

speaker up inside the cut-out hole. Center the speaker in the cut-out hole and

turn the six locking screws counterclockwise until the speaker is drawn up

snugly to the wall board from behind, clamping the speaker in place. Try to tight-

en each screw equally. Replace the speaker grill by gently pressing it into place. 

After making all connections it’s a good idea to make sure everything is working

properly. Turn on your stereo system making sure the volume control is turned

down and that the balance control is in the center position. Activate a musical

source such as FM, a CD or DVD player. Gently turn up the volume. You should

hear music coming from your new NXG speakers. If no sound is heard from

any or all speakers, switch off the system immediately and check for open or

loose connections, wrong polarity or shorts.