3com 8807 Guida Di Riferimento

C

HAPTER

 3: C

ONFIGURATION

 F

ILE

 M

ANAGEMENT

 C

OMMANDS

display this

Any view

None

Use the display this command to display the running configuration of the current 
view. If you need to authenticate whether the configurations is correct after you 
have finished a set of configurations under a view, you can use the display this 
command to view the running parameters.

Some effective parameters are not displayed if they are the same with the default 
ones, while some parameters, though have been configured by the user, if their 
related functions are not effective, are not displayed either. For example, if X.25 is 
encapsulated at the data link layer on an interface, you can configure PPP 
parameter on the interface, but cannot view the configuration information when 
executing the display this command.

Associated configuration of the interface is displayed when executing the 
command in different interface views; related configuration of the protocol view is 
displayed when executing this command in different protocol views; and all the 
configuration of the protocol view is displayed when executing this command in 
protocol sub-views.

Related command: save, reset saved-configuration, display 
current-configuration, display saved-configuration.

# Display the running configuration parameters for the current view of the switch 
system.

<SW8800> display this 

Any view

None

Use the display startup command to display the related system software and 
configuration filenames used for the current and the next start-ups.

This command is used to display the following information: the filename of the 
system software for the current enabling configured by the user, the filename of