3com 8807 Guida Di Riferimento
IP Subnet-Based VLAN Configuration Commands
87
mode: Specifies the VLAN based on other protocols.
The following protocols can be supported:
all: Supports all the protocols.
Description
Use the protocol-vlan command to specify the parameters of VLANs based on
AppleTalk, IPX, and so on.
AppleTalk, IPX, and so on.
Use the undo vlan-type protocol command to cancel this configuration.
Related command: display protocol-vlan vlan.
Example
# Specify VLAN 5 based on AppleTalk.
[3Com-vlan5] protocol-vlan at
IP Subnet-Based VLAN
Configuration
Commands
Configuration
Commands
display vlan-ip vlan
Syntax
display vlan-ip vlan { vlan-list | all }
View
Any view
Parameter
vlan-list: Displays the information of a specified IP subnet-based VLAN, in the form
of vlan-list = { vlan-id [ to vlan-id ] }.
of vlan-list = { vlan-id [ to vlan-id ] }.
all: Displays the protocol information and indexes of all the IP subnet-based
VLANs.
VLANs.
Protocol mode
Parameter
Description
Ethernet II-based VLAN
ethernetii etype etype-id
etype-id: Indicates the
Ethernet type of an inbound
packet, in the range of 600 to
FFFF
Ethernet type of an inbound
packet, in the range of 600 to
FFFF
etype-id: Indicates the
Ethernet type of an inbound
packet, in the range of 600 to
FFFF
Ethernet type of an inbound
packet, in the range of 600 to
FFFF
llc dsap dsap-id ssap ssap-id dsap-id: Indicates a
destination service access
point, in the range of 0 to FF
point, in the range of 0 to FF
ssap-id: Indicates a source
service access point, in the
range of 0 to FF
service access point, in the
range of 0 to FF
SNAP-based protocol
snap etype etype-id
etype-id: Indicates the
Ethernet type of an inbound
packet, in the range of 600 to
FFFF
Ethernet type of an inbound
packet, in the range of 600 to
FFFF