3com S7906E Istruzione Sull'Installazione
2-1
2
Features
The following sections provide an overview of the main features of each module supported by the
S7900E series.
Access Volume
Table 2-1 Features in Access volume
Features
Description
Ethernet Port
This document describes:
z
Combo Port Configuration
z
Management Ethernet Interface Configuration
z
Basic Ethernet Port Configuration
z
Configuring Flow Control on an Ethernet Port
z
Configuring the Suppression Time of Physical-Link-State Change on
an Ethernet Port
an Ethernet Port
z
Configuring Loopback Testing on an Ethernet Port
z
Configuring a Port Group
z
Configuring an Auto-negotiation Transmission Rate
z
Configuring Storm Suppression
z
Setting the Interval for Collecting Ethernet Port Statistics
z
Enabling Forwarding of Jumbo Frames
z
Enabling Loopback Detection on an Ethernet Port
z
Configuring the MDI Mode for an Ethernet Port
z
Testing the Cable on an Ethernet Port
z
Configuring the Storm Constrain Function on an Ethernet Port
z
Configuring the Connection Mode of an Ethernet Port
Link aggregation
Link aggregation aggregates multiple physical Ethernet ports into one
logical link. This document describes:
logical link. This document describes:
z
Introduction to Link Aggregation
z
Configuring an Aggregation Group
z
Configuring an Aggregate Interface
z
Configuring a Load Sharing Mode for Load-Sharing Link Aggregation
Groups
Groups
Port Isolation
The port isolation feature allows you to isolate different ports within the
same VLAN. This document describes:
same VLAN. This document describes:
z
Introduction to Port Isolation
z
Configuring the Isolation Group
Service Loopback
Group
Group
To increase service redirecting throughput, you can bundle multiple
service loopback ports into a logical link, called a service loopback group.
This document describes:
service loopback ports into a logical link, called a service loopback group.
This document describes:
z
Introduction to Service Loopback Groups
z
Configuring a Service Loopback Group