Pico Macom dsp806 Guida Utente

Rev. 01/03

When connecting the DSP806 directly to a TV set, attenuate the output sufficiently to pre-
vent overdriving the TV set. The input level to the TV should be 5 dBmV.

1. Connect the I.F. jumper from the I.F. output to the I.F. input on the rear panel.

2. Connect the DSP806 to a 115 VAC grounded receptacle. Observe the lit LED light indicating power is on.

3. Connect the antenna input signal and check the level at the input test point using a signal level meter or spectrum analyzer. The level

must be at 0 dBmV minimum for a minimum carrier to noise ratio of 45 dB.

4. Connect the signal level meter or spectrum analyzer to the -30dB TEST POINT (front panel) and adjust the output level control to

desired level.

5. Verify performance by connecting a TV to the output test point or through an attenuator (50 dB) to the RF output. The input level to

the TV should be 0 to 10 dBmV maximum.

117 VAC

60 Hz 35 W

600W MAX

125V

0.5A

RF IN

IF OUT

IF IN

RF OUT

FUSE

CAUTION: 

FOR CONTINUED PROTECTION AGAINST FIRE

HAZARD,  USE ONLY WITH SAME TYPE 0.5A 125V FUSE

ANTENNA

RF IN
(ANTENNA INPUT, 0 dBmV MINIMUM)

RF OUT (TO TV)

40dB ATTENUATOR
(FAM-20, 2 PCS.)

I.F.LOOP