Xanté aw 1200 Guida Utente
6-20 – Printing on Various Media and Options
b.
Push the female IDE cable connector securely into the male IDE hard
disk connector (fig. 6.25).
disk connector (fig. 6.25).
5.
Reinstall the controller board into the printer.
a.
Grasp the controller board by the front, right corner and the left memory
bank latch and align the board over the printer at a slight angle (fig. 6.26).
bank latch and align the board over the printer at a slight angle (fig. 6.26).
Fig. 6.26 Align Controller Board
Fig. 6.27 Lower Controller Board into Place
b.
Lower the controller board carefully into place making sure the interfaces
on the board slide into their respective printer slots (fig. 6.27).
on the board slide into their respective printer slots (fig. 6.27).
Make sure to thread the parallel interface wires through the printer’s parallel interface
slot carefully so that they do not get bent.
slot carefully so that they do not get bent.