Xerox 220e Guida Di Riferimento
Printing Reference
2-1
Chapter
2
Printing From a
Macintosh
Using the Macintosh printer driver
System requirements
The Tektronix printer driver for the Macintosh requires the following
hardware and software:
hardware and software:
■
An Apple Macintosh II computer (or later)
■
At least 4 Mbytes of memory
■
System Software version 6.0.7 or 7.0 and higher
Installing the driver
The Phaser 220 driver is a Tektronix-modiÞed version of Apple's LaserWriter
7.1.2 printer driver. This driver includes special paper sizes and TekColor
color correction options. This installation procedure uses Apple's Installer
program to load the software for the Phaser 220 Driver onto your computer's
hard disk. The Installer also loads the LaserWriter 7.1.2 software if you are
using system software 6.0.7.
7.1.2 printer driver. This driver includes special paper sizes and TekColor
color correction options. This installation procedure uses Apple's Installer
program to load the software for the Phaser 220 Driver onto your computer's
hard disk. The Installer also loads the LaserWriter 7.1.2 software if you are
using system software 6.0.7.
If the printer is shared on a network, install the same version of the Tektronix
driver on all Macintosh computers connected to the network.
driver on all Macintosh computers connected to the network.
Note
LaserWriter 7.1.2 software is required to operate the Tektronix
driver. It is automatically installed for system software 6.0.7
users. If you have system software 7.0 with LaserWriter 7.1.2
already installed, the Installer does not update these Þles.
driver. It is automatically installed for system software 6.0.7
users. If you have system software 7.0 with LaserWriter 7.1.2
already installed, the Installer does not update these Þles.