Xerox 740 Guida Utente

SNMP (Simple Network Management Protocol) allows you to use an SNMP 
monitoring station to query the printer remotely for its status.  You can provide the 
following information for the printer to send to your SNMP utility:

■

Printer's name.

■

Name of contact person for printer problems.

■

Printer's location.

■

 Trap host's IP or IPX address.   Members 

of this list receive asynchronous SNMP traps (error and status messages) 
from the printer.

■

 Trap host's IP address 

and community name.   Members of this list receive asynchronous SNMP 
traps (error and status messages) from the printer.        

There are two ways to set SNMP parameters:

■

With a TCP/IP connection and a World Wide Web browser, you can use 
PhaserLink Printer Management Software.  See “Setting SNMP parameters 
using PhaserLink Printer Management Software” on page 81.

■

Send the appropriate PostScript file to the printer.  See “Setting SNMP 
parameters using a PostScript utility file” on page 82.

With a TCP/IP connection and a World Wide Web browser, you can use PhaserLink 
Printer Management Software to set host access.  For more information on 
PhaserLink software, see Chapter 12, “PhaserLink Printer Management Software”.

Click Configuration; this displays the View and Configure Settings page.

On the View and Configure Settings page, click View and Configure 
Interface Settings

; this displays the View and Configure Interface 

 page.             

On the View and Configure Interface Settings page, click View and 
Configure SNMP Settings

; this displays the View and Configure SNMP 

 page.             

On the View and Configure SNMP Settings page, enter the information 
for the SNMP utility.

Enter the validation password (if one has been assigned), and  click 
Do/Apply

.

Phaser 350, 360, 550, and 560 printers support RFC 1759, The Printer MIB.  
Phaser 740, 780, and 360 printers support SNMP traps within RFC 1759.