Infocus IN42 Manuale Hardware
35
4
Loosen the three captive screws (marked by the arrows) on the lamp
module.
module.
5
Carefully remove the lamp module by grasping and lifting the handle.
Dispose of the lamp in an environmentally proper manner.
Dispose of the lamp in an environmentally proper manner.
6
Install the new lamp module, making sure that it is properly seated, and
tighten the three captive screws.
tighten the three captive screws.
7
Replace the cover over the lamp module by sliding it back into place and
tightening the screw.
tightening the screw.
8
Plug in the power cable, press the power switch then press the Power
button to turn the projector back on. Reset the lamp hour timer by navi-
gating to the Settings>Service menu and selecting Reset Lamp Hours.
button to turn the projector back on. Reset the lamp hour timer by navi-
gating to the Settings>Service menu and selecting Reset Lamp Hours.
loosen the captive screws on lamp module
lamp module handle
reset lamp hours in Service menu
EDX Ref Guide.fm Page 35 Friday, June 30, 2006 10:48 AM