Infocus lp815 Guida Alla Connessione
WARNINGS:
•
To avoid burns, allow the projector to cool for at least 60 minutes before
you replace the lamp.
you replace the lamp.
•
Do not drop the lamp module. T he glass may shatter and cause injury.
•
Do not touch the glass lamp screen. Fingerprints can obscure projection
sharpness.
sharpness.
•
Be extremely careful when removing the lamp housing. In the unlikely
event that the lamp ruptures, small glass fragments may be generated.
T he lamp module is designed to contain most of these fragments, but
use caution when removing it.
event that the lamp ruptures, small glass fragments may be generated.
T he lamp module is designed to contain most of these fragments, but
use caution when removing it.
5
C arefully remove the lamp module by grasping and lifting the metal
bail wire. D ispose of the lamp in an environmentally proper manner.
bail wire. D ispose of the lamp in an environmentally proper manner.
6
Install the new lamp module, making sure that it is properly seated.
7
Tighten the three screws.
8
R eplace the lamp door by inserting the tabs into the tab bays and tight-
ening the two screws.
ening the two screws.
9
Plug in the power cable, press the power switch then press the Power
button to turn the projector back on.
button to turn the projector back on.
10
R eset the lamp hour timer.
Resetting the lamp timer
and then the increase volume button within 3 seconds.
A t that point the L E D will turn green and you can power on the projector.
A t that point the L E D will turn green and you can power on the projector.
You can also navigate to the Settings>Service menu and select Lamp Reset
to reset the lamp timer.
to reset the lamp timer.
remove module using bail wire
reset lamp time in Service menu