ICOM ic-207h Manuale Istruttivo
1
PANEL DESCRIPTION
5
■ Rear panel
q
w
r
e
q
ANTENNA CONNECTOR [ANT]
Accepts a 50
Ω dual band antenna with a PL-259 connec-
tor. (p. 14)
w
SPEAKER JACK [SP]
Connects a 4–8
Connects a 4–8
Ω speaker, if required. Outputs the se-
lected band’s audio.
e
DATA JACK [DATA]
6-pin mini DIN jack to connect a TNC, etc. for packet op-
eration.
6-pin mini DIN jack to connect a TNC, etc. for packet op-
eration.
NOTE: The connection between this jack and the TNC
differs depending on whether 1200 bps or 9600 bps op-
eration is chosen in initial set mode (p. 63). See right
for pin assignments.
differs depending on whether 1200 bps or 9600 bps op-
eration is chosen in initial set mode (p. 63). See right
for pin assignments.
r
POWER RECEPTACLE [DC13.8V]
Accepts 13.8 V DC with the supplied DC power cable.
Accepts 13.8 V DC with the supplied DC power cable.
D DATA JACK PIN ASSIGNMENTS
q
DATA IN
(1200 bps: AFSK
9600 bps: G3RUH,
GMSK)
w
GND
e
PTTP
r
DATA OUT (9600 bps)
t
AF OUT (1200 bps)
y
SQ
q DATA IN
Input terminal for data transmit. See p. 63 for details on
how to toggle data speed between 1200 and 9600 bps.
how to toggle data speed between 1200 and 9600 bps.
w GND
Common ground for DATA IN, DATA OUT and AF OUT.
e PTTP
PTT terminal for packet operation only. Connect ground to
transmit data.
transmit data.
r DATA OUT
Data out terminal for 9600 bps operation only.
t AF OUT
Data out terminal for 1200 bps operation only.
y SQ (squelch out)
Becomes high (+5V) when the transceiver receives a sig-
nal which opens the squelch.
nal which opens the squelch.
• To avoid unnecessary TNC transmission, connect squelch to the
TNC to inhibit transmission when receiving signals.
• Keep audio output at a normal level, otherwise a “SQ” signal will
not be output.