Teltone m-392 Guida Utente

A number of operating parameters in the LSS can be adjusted by the customer. The
programming options are listed in Table 2. The LSS is programmed using a DTMF
telephone keypad, either locally or remotely.

All commands start with

and end with #. # is also used to separate the parts of the

command. In general, the formats are as follows:

<command>#

(no data entry)

<command>#<x>#

x = (single data field)

<command>#<x>#<x>#

x#x = (multiple data fields)

To cancel the entire command, enter:

∗

in a command field.

To abort the entire command, enter

in a data field.

If no data is entered in a field, that field is either cleared or set to zero. With
enable/disable functions, an entry of 0 in the data field disables a feature; 1 enables it.

When a command has been successfully entered, a confirmation tone (three short
beeps) is returned to the user.

When a command has been entered incorrectly, an error tone (one long beep) is returned
to the user.

Remember: the LSS will exit the programming mode and disconnect if 60 seconds elapse
without entry of any DTMF digits.

Table 2 outlines the commands and provides information about the valid entries and
factory defaults. We have provided a column (Customer Settings) in which you can enter
your selections as you program the unit. We suggest that you use the column as it can
help you keep track of the unit’s settings.

Please make your entries in pencil, as you may

wish to change them at a later date.

40-400-00015, Rev. 

F

Page 15