Teltone m-392 Guida Utente
Chapter 1: Getting Started
Installation and setup may require that a person be on-site with the Polling Controller and
another person on site with the Line Sharing Switch.
another person on site with the Line Sharing Switch.
Please note that programming of an LSS is not required to operate the LSS . You
should program only if you wish to customize the system for your application.
should program only if you wish to customize the system for your application.
Where to Start
Review Chapter 2, Overview, then Chapter 3, Installing the LSS, and then select one of
the chapters below to get started.
the chapters below to get started.
Chapter 4 - Teltone Default LSS Operation with Polling Controller
M-392-B-02, M-393-B-02, M-394-B-02, M39X-A&5
Chapter 5 - Standalone Operation and Programming
M-392-B-01, M-393-B-01, M-394-B-01, M-39X-A&4
•
To setup the LSS, follow the instructions in Chapter 3.
Note:
When you have finished installation and have tested each LSS, you can program
the unit to operate with different commands. The factory defaults, which are used until
you program the unit, let you get started and operate the unit immediately.
you program the unit, let you get started and operate the unit immediately.
Chapter 6 - Advanced Applications
Multiple Unit
•
This configuration is intended for experienced users only. Follow the instructions to
install, test, and program new port Transfer Codes.
install, test, and program new port Transfer Codes.
Product Registration
Fill out the Product Registration card and return it to Teltone Corporation.
Reference Manual
Chapter 1: Getting Started
40-400-00015, Rev.
F
Page 1