Pioneer dvr-7000 Manuale Supplementare

 
 

1. Switch on your European Pioneer DVR-7000 DVD-R/RW Recorder. Enter "setup" by pushing the 
button labelled "setup" on your DVR-7000 remote control unit. 

 
2. By using the "joystick" of your DVR-7000 remote control unit change to "Initial Setup" and press 
enter (by pushing the "joystick" on your DVR-7000 remote control unit). 

 
3. Highlight the "Audio Out" tab on the left of the screen by using the "joystick" of your DVR-7000 

remote control unit, next move to "Digital Out" in the central zone, and finally continue to the outer 
right highlighting the "On" position (note: whether this setting is actually in "on" or "off" position is 

not important for this purpose). 
 

4. Now on your DVR-7000 remote control unit first press the "SHIFT" button, and then the "ANGLE" 
button. 
 

 

 
Extra information will now be displayed in the previously empty area below the "on/off" section of 

the screen. 
The last 3 digits of the first line of the newly displayed information contains the firmware version 

information needed: 
 

e.g.: " SYSCON : RELEASE_160 " would indicate that your Pioneer DVR-7000 DVD-R/RW Recorder 
has firmware release version "1.60". 

 
 
(*) 

 this information applies only to the European versions of the DVR-7000; a 

European DVR-7000 can by identified by the presence of 2 EuroSCART ("AV Connector") sockets 
located at the rear of the unit.