Epson 600 Guida Utente

Problems and Solutions

■

Make sure the recipient’s fax machine is turned on and working. 

■

Make sure the 

LINE

 port on the WorkForce 600 Series is connected to a 

telephone wall jack. Verify that the telephone wall jack works by connecting a 
phone to it.

■

If the line has static, press the 

Home

 button and select 

Setup

. Select 

Fax Setting

 and press 

OK

, then select 

Communication

 and press 

OK

. Turn 

off the 

V.34

 and 

ECM

 (Error Correction Mode) settings.

■

If the WorkForce 600 Series is connected to a DSL phone line, you must have 
a DSL filter connected to the phone jack. Contact your DSL provider for the 
necessary filter.

■

If fax calls are disconnected when you hang up, make sure a phone or 
answering machine is connected to the EXT. port.

■

If an answering machine is connected, be sure to set the number of rings to 
answer for receiving faxes to be greater than the number of rings for the 
answering machine.

■

For the best print quality, use Epson papers (see page 6) and genuine Epson 
ink cartridges (see page 40).

■

If you notice light or dark bands across your printouts or they are too faint, 
run a nozzle check (see page 36) to see if the print head needs cleaning.

■

If you notice jagged vertical lines, you may need to align the print head. See 
the on-screen Epson Information Center for instructions.

■

The ink cartridges may be low on ink. Check your cartridge status (see 
page 38) and replace cartridges, if necessary (see page 40).

■

If you’re copying, place the document flat against the scanner glass. 

■

Clean the scanner glass with a soft, dry, lint-free cloth (paper towels are not 
recommended), or use a small amount of glass cleaner on a soft cloth, if 
necessary. Do not spray glass cleaner directly on the glass.