Epson RX620 Descrizione Prodotto

Epson Stylus Photo RX620

14 -

 Epson Stylus Photo RX620

11/04

1. Position the film holder so that the 35 mm slide section 

faces the center of the scanner glass. The positioning posts 
fit in two small holes near the scanner lid, as shown. 

2. Places slides in the film holder as shown, with the duller 

(emulsion) side facing up. 

Note:
If your slide image is in landscape orientation (wider than it is 
long), place it in the same direction as slide images in portrait 
orientation (longer than they are wide). This copies the maximum 
image area, but your preview will be rotated.

3. Close the scanner lid.

Now you are ready copy, print, or scan. See the User’s Guide 
for instructions. 

If your printouts are unexpectedly light, or dots or lines are 
missing, you may need to clean the print head. This unclogs 
the nozzles so they can deliver ink properly. Print head 
cleaning uses ink, so clean it only if quality declines. 

Note:
You can also clean the print head using the printer software. Click the 
? or Help button on your printer settings window for instructions on 
running the print head cleaning utility.

1. Make sure the RX620 is turned on but not printing.

2. Press the 

Setup

 button to enter setup mode.

3. Press the u and d buttons to select 

Head cleaning

.

4. Press the 

OK

 button, then press 

OK

 to start cleaning the 

print head.

Cleaning takes about 30 seconds, during which the message 

Head Cleaning

 appears on the LCD screen.

Caution: 
Never turn off the RX620 while the message Head Cleaning 
appears on the LCD screen, unless the RX620 hasn’t moved or 
made noise for more than 5 minutes.

5. When head cleaning is finished, you return to the Setup 

Menu. Use the u and d buttons to select 

Nozzle Check

. 

6. Make sure letter-size paper is loaded. Press the 

OK

 button, 

then press 

OK

 to print a nozzle check.

Note:
You can also print a nozzle check using the printer software. Click 
the ? or Help button on your printer settings window for 
instructions on printing a nozzle check.

7. Examine the nozzle check pattern you printed. Each 

staggered line should be solid, with no gaps, as shown. 

❏ If your printout looks okay, you’re done. Click 

Cancel

 

to return to the main menu. 

❏ If you see any gaps (as shown below) in the dot pattern, 

press 

OK

. Then follow the instructions on the LCD 

screen to clean the print head again. 

Flourescent 
lamp

Film strip is 
in middle 
of glass

Make sure the top of 
images with portrait 
orientation face the 
front of the RX620