Epson RX620 Guida All'Installazione Rapida
1
Open the scanner lid and remove the yellow sticker. Then unlock
the scanner as shown.
the scanner as shown.
Note: You can store the film holder in the scanner lid behind the
white document mat.
white document mat.
2
Lift open the scanner section to access the printer area.
3
Remove the orange print head lock and store it as shown.
Epson Stylus
®
Photo RX620
Star t Here
1
Plug your Stylus Photo RX620 into an electrical outlet, then press the
O n button. The green light comes on and the ink cartridge holder
moves to the left.
O n button. The green light comes on and the ink cartridge holder
moves to the left.
2
Open the ink cartridge holder.
3
Remove the ink cartridges from their packages
4
Insert each ink cartridge, then press it down so it clicks into place.
5
Close the ink cartridge holder, then close the scanner section.
Install Ink Cartridges
4
1
Open the output tray.
2
Flip the feeder guard forward and slide the edge guide to the left.
3
Place a stack of paper against the right side of the sheet feeder.
Slide the edge guide lightly against the left side of the paper.
Slide the edge guide lightly against the left side of the paper.
5
Press the O K button to start ink charging. Wait about 2 minutes
until charging completes.
until charging completes.
1
Make sure you have all the parts shown here. If any parts are missing,
contact Epson
contact Epson
®
as described on the back of this sheet.
2
Remove all the blue packing tape from the Stylus Photo RX620.
Caution: Do not remove the yellow stickers until instructed.
3
Insert the paper support.
4
Connect the cable.
Unpack and Assemble
Turn over
1
5
Load Paper
Unlock
2
Paper support
Software
CD-ROM
CD-ROM
Quick Guide
Epson Stylus Photo RX620
Ink cartridges
(6 total)
Film and slide holder
CPD-18568
Printed in XXXXXX XX-XX.XX XXX
Printed in XXXXXX XX-XX.XX XXX
On button
Press
OK button
1
Remove the yellow sticker over the USB port and plug the square
end of your USB cable into the port, as shown below.
end of your USB cable into the port, as shown below.
Caution: Do not connect the cable to your computer until you
have installed the software.
have installed the software.
Connect the Cable
3
2
Route the cable in the channel along
the side of the RX620, as shown.
the side of the RX620, as shown.
Edge guide
CPD18568_Patt_SH_E.qxd 9/3/04 3:49 PM Page 1