Epson 310 Manuale Utente

Solving Problems

Verify that the printer is turned on and connected to your network (see “Connect 
an Ethernet Network Cable” on page 5). Click 

Next

 to search for your printer on 

the network. Then continue with step 9 on page 8.

Make sure that the printer is connected to your network (see page 5). Then 
remove and reinsert the CD to reinstall the printer software.

Make sure the printer driver was installed correctly and that your computer’s
TCP/IP settings are configured correctly. 

■

Print a Network Status Sheet (see page 53) and verify that the network 
settings are correct.

If the Network Status is Disconnected, check your Ethernet cable connections 
and try turning the printer off and back on again.

■

When using TCP/IP, make sure the printer’s IP address is set correctly for your 
network. If your network does not assign IP addresses using DHCP, you need 
to set the IP address manually.

■

Make sure that the printer is turned on, and that your router, access point, 
switch, or hub link LED for the port the printer is connected to is on or 
flashing. If the link LED is off, try the following:

■

Make sure the Ethernet cable is securely connected to both the printer 
and your router, access point, switch, or hub.

■

Try connecting to another port on your router, access point, switch, or 
hub.

WF310_QG.book  Page 52  Wednesday, April 8, 2009  2:14 PM