Epson 2000 Manuale Utente

Before connecting your printer to a computer, use the built-in

self-test function to see that the printer is working properly.

Before running the self test, you need to connect your printer to

an electrical outlet.

1. Make sure that the printer is turned off.

2.

Check the label on the back of the printer to make sure the

power rating required by the printer matches that of your
electrical outlet.

CAUTION: 

If the rated voltage and your outlet voltage

do not match, contact your dealer for assistance. Do not

plug in the power cord.

3.

If necessary, connect the power cord to the AC inlet on the
printer’s back panel.

4.

Plug the power cord into a properly grounded electrical outlet.

The self test runs in draft or Near Letter Quality (NLQ) mode,

depending on which button you hold down as you turn on the

printer.

1.

Make sure that the printer is turned off and then push the

paper release lever back to the single-sheet position.

2. While holding down the 

button (draft mode) or 

button (NLQ mode), turn on the printer. The 

and

lights come on.

1-10