Epson 900 Guida Utente
Introduction
4
Windows System Requirements
To use the EPSON Stylus RIP in either a standalone or
peer-to-peer network environment, your system should include:
◗
◗
IBM
®
-compatible PC with 486 or higher processor
(Pentium
®
133 MHz or higher recommended)
◗
Microsoft Windows 95/98 or Windows NT 4.0
◗
At least 16MB of RAM (32MB or more recommended)
◗
At least 50MB of free hard disk space to install the software
and at least 150MB of free hard disk space for processing
files (more for large files)
◗
CD-ROM drive
◗
An available parallel port configured as LPT1
You can print with the EPSON Stylus RIP on a peer-to-peer
Windows network by using file sharing, with the printer
connected to the print servers parallel port. In this networked
environment, you install the EPSON Stylus RIP software on the
print server only, and install the PostScript printer driver on all
your other networked computers. See page 3-4 for instructions.
How To Use Your Manuals
Before you install the RIP, make sure you set up your printer and
install the standard EPSON non-PostScript driver that came
with your printer, following the instructions in your printers
setup guide. Refer to your EPSON printers users guide for
instructions on using and maintaining your printer.
If youre familiar with software PostScript interpreters, you can use
the EPSON Stylus RIP Quick Start Guide to get started with the RIP.
Nflight.bk Page 4 Thursday, April 22, 1999 5:02 PM