Epson 900 Guida Utente

1-2

Installing EPSON Stylus RIP for Macintosh

Checking the Printer

Before you install the EPSON Stylus RIP software, follow the 

instructions in your printer’s setup guide and user’s guide to 

prepare your printer for use. Make sure you perform the 

following steps:

◗

If you’ll be using the printer in a “typical” network 

configuration (described in the following section), install an 

optional network interface card in the printer. (Not every 

printer has a network interface card option.) See your 

printer’s user’s guide for instructions.

◗

Load paper, install ink cartridges, and allow your printer to 

complete its entire ink charging cycle. 

◗

Run a printer self test to make sure it operates properly.

◗

Connect the printer directly to your Macintosh or to the 

network.

◗

Install the standard non-PostScript EPSON driver and 

utilities that came with your printer.

◗

Send a sample print job with the standard printer driver to 

make sure the interface connection and cable are secure and 

the software is installed correctly.

Once the printer is set up and tested fully, you’re ready to 

install the EPSON Stylus RIP software on your system.

Nflight.bk  Page 2  Thursday, April 22, 1999  5:02 PM