Epson ES-300GS Guida Specifiche

Connector type:

 D-SUB 

In this table, the direction of the signals is given relative to

the scanner.

The scanner 

can 

be initialized (returned to a fixed set of

conditions) in the following ways.

Hardware initialization:

 

 the power is turned on.

 When the scanner receives an 

 signal at the parallel

interface (pin 31 goes low).

 the scanner receives a SCSI Reset signal at the SCSI

interface.

Software initialization:

 When the software command 

   (initialize the

scanner) is received.
When the SCSI Bus Device Message is received.

 problems you may have while using the scanner often

involve the operation of your software and computer.

Problems fall in the following major categories:

 Incorrect setup of the interface
 Inappropriate selection of the 

 functions

Incorrect setup of your computer or software

 Incorrect operation of your software
 Incorrect loading of documents.

Also see the documentation that came with your software

and computer for possible solutions.

If an error occurs, the scanner stops operating and the

and 

show the 

 of error.

The scanner has received incorrect commands from your

scanning software. When this error occurs, retry the scanning

operation. The scanner returns to normal operation when it

receives correct commands. Normally you do not need to

scanner, which is done by turning the scanner off

and then on.

The scanner may not be properly connected to the computer.
Check the interface 

 turn the 

 off

and back on to reset it.
The interrupt settings or the port addresses for the interface

board 

be set correctly or may conflict with 

installed expansion boards.