GoVideo t1530 Scheda Rapida Di Riferimento
tv setup
video adjust
v-chip block
closed caption
audio
options
video adjust
v-chip block
closed caption
audio
options
auto set
press <+> to select
edit channels press <+> to select
auto fine tune
auto fine tune
on off
fine tune
source
source
antenna
50
Read Me First
Unpacking & Initial Setup
T1530
UNPACK YOUR LCD TV
• T1530 LCD TV (1)
• Remote control (1)
• 1.5V AAA alkaline batteries (2)
• RF (Antenna) cable (1)
• User's guide (1)
• Quick reference guide (1)
• Warranty registration card (1)
• AC Adapter (1)
• T1530 LCD TV (1)
• Remote control (1)
• 1.5V AAA alkaline batteries (2)
• RF (Antenna) cable (1)
• User's guide (1)
• Quick reference guide (1)
• Warranty registration card (1)
• AC Adapter (1)
INSERT REMOTE CONTROL BATTERIES
1 Remove battery cover on back of remote control.
2 Insert two 1.5V AAA batteries, paying attention to the
1 Remove battery cover on back of remote control.
2 Insert two 1.5V AAA batteries, paying attention to the
correct polarities (+/-).
3 Replace cover.
1
2
3, 4
5
MEMORIZE CHANNELS
1 Press MENU to bring up the Setup menu.
2 Use the CH / buttons to select TV SETUP, then press VOL+.
3 Use the CH / buttons to select SOURCE.
4 Press VOL+ repeatedly to select the type of signal you are using to receive channels:
1 Press MENU to bring up the Setup menu.
2 Use the CH / buttons to select TV SETUP, then press VOL+.
3 Use the CH / buttons to select SOURCE.
4 Press VOL+ repeatedly to select the type of signal you are using to receive channels:
ANTENNA, CABLE (Standard, HRC, or IRC).
5 Use the CH / buttons to select AUTOSET, then press VOL+.
• The TV automatically searches for all available channels and stores them to memory.
This takes approximately one or two minutes.
• When finished, the TV automatically displays the lowest channel found.
From
Antenna
To
Outlet
From
Cable TV
OR
LCD TV
BASIC SETUP
1 Connect the RF cable from your antenna or cable TV jack to the ANT jack on the back panel of the LCD TV.
2 Connect the supplied AC Adapter to the POWER/DC12V jack on the back panel of the LCD TV and plug it into a wall outlet.
3 Press the POWER button on the front panel to turn the TV on. The green Power LED lights.
1 Connect the RF cable from your antenna or cable TV jack to the ANT jack on the back panel of the LCD TV.
2 Connect the supplied AC Adapter to the POWER/DC12V jack on the back panel of the LCD TV and plug it into a wall outlet.
3 Press the POWER button on the front panel to turn the TV on. The green Power LED lights.
• Now use the POWER button on the remote control to switch between On and Standby (low power) mode. The red Power
LED will light in Standby mode.
• If you press POWER on the front panel, the Power LED turns off. This is equivalent to unplugging the TV.
channel searching
23
tv setup
video adjust
v-chip block
closed caption
audio
options
video adjust
v-chip block
closed caption
audio
options
auto set
press <+> to select
edit channels press <+> to select
auto fine tune
auto fine tune
on off
fine tune
source
source
antenna
50
tv setup
video adjust
v-chip block
closed caption
audio
options
video adjust
v-chip block
closed caption
audio
options
50
auto set
press <+> to select
edit channels press <+> to select
auto fine tune
auto fine tune
on off
fine tune
source
source
antenna