Cisco 2600 Enterprise Plus Feature Pack CD26-AP-12.0.7= Manuale Utente

20 Release Notes for Cisco IOS Release 12.0(7)XK1 Feature Packs for Cisco 2600 Series Routers

To use an rcp application, follow the procedure below, substituting “rcp” for “TFTP”and

using the copy rcp flash command instead of the copy tftp flash command.

Install any TFTP server application on the PC. (A PC application is included on the
feature pack CD-ROM for Microsoft Windows 95 only.)

Launch the TFTP server application on the PC, usually by double-clicking the application
icon or its .exe filename.

Set up the PC as a TFTP server by using the TFTP server application setup or
configuration facility.

Most TFTP server applications include a setup facility that allows you to specify the PC
as a server. For example, from the TFTP menu of one application, you can select Settings
to display a panel, and configure the local PC as a server by selecting the Server
checkbox.

The TFTP server also allows the selection of a “root” directory. You must select the
directory in which the Cisco IOS files reside (for example, d:\cpswinst\images).

Establish a console session from your local PC (which is now configured as a TFTP
server) to the Cisco router by using one of these methods:

•

Connect the PC com port to the router console port.

This is the recommended method.When you reload the router with the new image in
Step 25, you remain connected to the router. (If you use Telnet, you lose connection
to the router.)

•

Establish a Telnet session from the PC to the router.

Connect your PC Ethernet port to the corresponding router LAN port. Use the 10BaseT
crossover cable to connect to an Ethernet port. Use straight-through cables if you are
connecting via a 10BaseT hub or a 100BaseT hub.

We recommend that you back up the router configuration before upgrading the

router software.

Enter the following commands to set the configuration register to 0x2101 and reload to
the bootstrap image:

Router# config terminal

Router(config)# config-reg 0x2101

Router(config)# end

Router# reload

Make sure you set up your local PC as a TFTP server. If you overlook this step, you

cannot perform the copy procedure. This reminder applies to both TFTP and rcp.

Make sure your PC is set up to communicate with the 10BaseT Ethernet port on the

router.