Sony DSC-QX30 Manuale

4

Note
This equipment has been tested and found to comply with 
the limits for a Class B digital device, pursuant to Part 15 
of the FCC Rules.
These limits are designed to provide reasonable protection 
against harmful interference in a residential installation. 
This equipment generates, uses, and can radiate radio 
frequency energy and, if not installed and used in 
accordance with the instructions, may cause harmful 
interference to radio communications.
However, there is no guarantee that interference will not 
occur in a particular installation. If this equipment does 
cause harmful interference to radio or television reception, 
which can be determined by turning the equipment off and 
on, the user is encouraged to try to correct the interference 
by one or more of the following measures:

– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and 

receiver.

– Connect the equipment into an outlet on a circuit 

different from that to which the receiver is connected.

– Consult the dealer or an experienced radio/TV 

technician for help.

The supplied interface cable must be used with the 
equipment in order to comply with the limits for a digital 
device pursuant to Subpart B of Part 15 of FCC Rules.

Notice for the customers in the countries 
applying EU Directives
Manufacturer: Sony Corporation, 1-7-1 Konan Minato-ku 
Tokyo, 108-0075 Japan
For EU product compliance: Sony Deutschland GmbH, 
Hedelfinger Strasse 61, 70327 Stuttgart, Germany

Notice
If static electricity or electromagnetism causes data 
transfer to discontinue midway (fail), restart the 
application or disconnect and connect the communication 
cable (USB, etc.) again.

This product has been tested and found compliant with the 
limits set out in the EMC regulation for using connection 
cables shorter than 3 meters (9.8 feet).

The electromagnetic fields at the specific frequencies may 
influence the picture and sound of this unit.

This symbol on the product, the battery or on 
the packaging indicates that the product and the 
battery shall not be treated as household waste. 
On certain batteries this symbol might be used 

in combination with a chemical symbol. The chemical 
symbols for mercury (Hg) or lead (Pb) are added if the 
battery contains more than 0.0005% mercury or 0.004% 
lead. By ensuring these products and batteries are disposed 
of correctly, you will help prevent potentially negative 
consequences for the environment and human health 
which could otherwise be caused by inappropriate waste 
handling. The recycling of the materials will help to 
conserve natural resources.
In case of products that for safety, performance or data 
integrity reasons require a permanent connection with an 
incorporated battery, this battery should be replaced by 
qualified service staff only. To ensure that the battery and 
the electrical and electronic equipment will be treated 
properly, hand over these products at end-of-life to the 
applicable collection point for the recycling of electrical 
and electronic equipment. For all other batteries, please 
view the section on how to remove the battery from the 
product safely. Hand the battery over to the applicable 
collection point for the recycling of waste batteries. For 
more detailed information about recycling of this product 
or battery, please contact your local Civic Office, your 
household waste disposal service or the shop where you 
purchased the product or battery.