D-Link DAS-3626 Manuale Utente
Connecting to the Switch
The console interface is used by connecting the switch to a VT100-compatible terminal or a computer running an
ordinary terminal emulator program (e.g., the HyperTerminal program included with the Windows operating
system) using an RS-232C serial cable. Your terminal parameters will need to be set to
ordinary terminal emulator program (e.g., the HyperTerminal program included with the Windows operating
system) using an RS-232C serial cable. Your terminal parameters will need to be set to
:
•
VT-100 compatible
•
115200 baud
•
8 data bits
•
No parity
•
One stop bit
•
No flow control
Users can also access the same functions over a Telnet interface. Once users have set an IP address for your
Switch, users can use a Telnet program (in VT-100 compatible terminal mode) to access and control the switch.
All of the screens are identical, whether accessed from the console port or from a Telnet interface.
After the switch reboots and users have logged in, the console looks like this:
Switch, users can use a Telnet program (in VT-100 compatible terminal mode) to access and control the switch.
All of the screens are identical, whether accessed from the console port or from a Telnet interface.
After the switch reboots and users have logged in, the console looks like this:
DAS-3626 VDSL2 Switch
Command Line Interface
Firmware: Build 1.02-B018
Copyright(C) 2008 D-Link Corporation. All rights reserved.
UserName:
Figure 2-1. Initial Console screen after logging in
Commands are entered at the command prompt, DAS-3626:admin#.