Canon EOS-1Ds Manuale Istruttivo

162

The battery has almost exhausted.

s

Recharge the battery. (

→p.22)

Only the <

>

icon is displayed on
the top LCD panel.

The battery
cannot be
recharged.

You are using the wrong battery.

s

Use the dedicated Ni-MH Pack. (

→p.22)

The battery is not properly attached to the charger.

s

Attach the battery properly to the charger. (

→p.22)

The camera does
not operate even
when the <

>

switch is set to
<

>.

The battery is exhausted.

s

Recharge the battery. (

→p.22)

The battery is not installed properly.

s

Install the battery properly. (

→p.23)

The CF card slot cover is open.

s

Push in the CF card until the CF card release button pops up. Then
close the CF card slot cover. (

→p.27)

The access lamp
still blinks even
when the <

>

switch is set to
<

>.

If you set the <

> switch to <

> right after taking a picture, the

access lamp will still blink for a few seconds while the image is recorded
onto the CF card.

s

When the camera finishes recording the image to the CF card, the
access lamp will stop blinking and the power will turn off.

The battery
becomes
exhausted
quickly.

The battery is not fully charged.

s

Recharge the battery fully. (

→p.22)

The battery’s service life has expired.

s

Replace the battery with a new one. (

→p.166)

The camera turns
off by itself.

Auto power off is in effect.

s

Set the <

> switch to <

> again or set auto power off to “Off.”

(

→p.130)

If there is a problem, first refer to this Troubleshooting Guide.